# proglets.dat For Unit 032
#CTD SN 056
#Optode SN 1345
#--------------------------------------------------------------------------
# CTD41CP Sea-bird  CTD(SBE-41)
# Continuous Profile Unit
#          Seabird CTD              OES                       Persistor
#Hardware: Pin 1(Power CTRL)                                 Pin 27 (CTD5)
#          Pin 2(TX OUT)         J7pin25(UART4 RXC)
#          Pin 3(MODE)                                       Pin 26 (CTD6)
#
proglet = ctd41cp
    uart =     2    # UART4-RXC
    bit  =    27    # Power Ctrl
    bit  =    26    # MODE
    start_snsr=c_profile_on(sec)
    simulator = ctd41cp_sim
#------------------------------------------------------------------------
# Aanderaa Oxygen Optode 3835 
proglet = oxy3835
    uart       = 3          # U4Soem Pins T-2,R-3  (we only use receive)
    bit        = 34         # power control for sensor
    start_snsr = c_oxy3835_on(sec)
#------------------------------------------------------------------------
# Wet Labs flbbcd fluorometer, scattering meter, and cdom sensor
# NOTE: This proglet requires the following sensor specific constants from
#       Wet Labs for deriving engineering units (put in autoexec.mi):
#         u_flbbcd_chlor_cwo(nodim)      # clean water dark offset, nodim == counts
#         u_flbbcd_bb_cwo(nodim)         # clean water dark offset, nodim == counts
#         u_flbbcd_cdom_cwo(nodim)       # clean water dark offset, nodim == counts
#         u_flbbcd_chlor_sf(ug/l/nodim)  # scale factor to get units
#         u_flbbcd_bb_sf(Mnodim)         # scale factor to get units
#         u_flbbcd_cdom_sf(ppb/nodim)    # scale factor to get units
#         u_flbbcd_is_calibrated(bool) 1 # set to 1 after entering 
#                                        # calibration constants
#
# For simulator, set u_wetlabs_sim_num_eng_units(nodim) to 3 in autoexec.mi
#
proglet = flbbcd
    uart       = 0          # U4Soem Pins T-2,R-4  (we only use receive)
    bit        = 29         # power control for sensor
    start_snsr = c_flbbcd_on(sec)
    simulator = wetlabs_sim
#------------------------------------------------------------------------